(b)in Section D, points 2.1.4.1 and 2.1.4.2 are replaced by the following:‘2.1.4.1.The additional weight required for alternative fuel or zero-emission technology in accordance with point 2.3 of Annex I to Directive 96/53/EC, and, for the purpose of Article 2(1)(b) of Regulation (EU) 2019/631, the mass of the energy storage system of zero-emission vehicles, shall be defined on the basis of the documentation provided by the manufacturer. The correctness of the declared information shall be verified by the Technical Service, to the satisfaction of the Type-Approval Authority.2.1.4.2.The manufacturer shall indicate the following additional symbol as well as the value of the additional weight, in case of alternatively fuelled motor vehicles, or the mass of the energy storage system, in case of zero-emission motor vehicles, below or to the side of the mandatory inscriptions on the manufacturer’s statutory plate, outside a clearly marked rectangle which shall enclose only the mandatory information.“96/53/EC ARTICLE 10B COMPLIANT – XXXX KG”“(EU) 2019/631 ARTICLE 2(1)(b) COMPLIANT – XXXX KG”The height of the symbol’s characters and stated value shall not be less than 4 mm.In addition, until the introduction of a dedicated entry in the Certificate of Conformity, the value of the additional weight or the mass of the energy storage system shall be stated under “remarks” in the Certificate of Conformity, as to allow inclusion of this information in on-board vehicle registration papers, as follows:“Additional mass due to batteries: …… kg”note