Article 1, Point (15) · Commission Regulation (EU) 2019/1939

Contents

(15)in Annex VIII, point 5.1.2. is replaced by the following:‘5.1.2.Paragraph A.1.2.1 of Appendix 1 of Annex 12 to UNECE Regulation No 49 shall be understood as follows:

A.1.2.1.In order to receive an extension of an EU type-approval for a vehicle in respect of its engine type-approved under Regulation (EC) No 595/2009 and this Regulation to a vehicle with a reference mass exceeding 2380 kg but not exceeding 2610 kg, the manufacturer shall meet the requirements relating to the measurement of CO₂ emissions and fuel consumption established by the type 1 emissions test procedures set out in sub-annex 6 to Annex XXI to Commission Regulation (EU) 2017/1151 with only speed trace and RCB corrections. The CO₂ emissions shall be determined in accordance with table A6/2 not taking into account the criteria emission test results, where the vehicle during testing shall apply no AES and be considered as VH. The test reports specified in Appendices 8a part I until point 2.1. included and 8b of Annex I, to Commission Regulation (EU) 2017/1151, shall be submitted to the type approval authorities including the results of pollutant emissions.The manufacturer shall provide the type approval authority with a signed declaration that all variants and versions for which this extension is requested are in conformity with the type-approval emission requirements in Regulation (EC) No 595/2009 and that the type 1 test was performed in compliance with the previous paragraph.Existing EU type-approvals for a vehicle with a reference mass exceeding 2380 kg but not exceeding 2610 kg, in respect of its engine type-approved under Regulation (EC) No 595/2009, may be extended at the latest by the application date of this Regulation.For dedicated compression ignition engines fuelled with ethanol (ED95), a fixed carbon-hydrogen-oxygen ratio shall be used for the purposes of calculating fuel consumption values, which shall be C₁H_2,92O_0,46.””;